Custom Beginner

I had it then I lost it

...free time, that is. This afternoon was supposed to be empty. My Thursday class finishes at 1:30, I have no Friday classes, and this weekend is Fall Break so my next class isnt until Wednesday. I was even considering actually cleaning up the garage...thats how much time I was suppose to have. Then the doorbell rang...

FedEx...oh my, what could it be?


Looks like someone got a new saw kit, holdfast, and making knife...


I was a little surprised here. This package wasnt supposed to arrive until tomorrow. Then again, it was FedEx. Had they used USPS Im sure the package wouldve already been through Hartsfield-Jackson twice and currently be en route to Nome, Alaska via dog sled.

So as I said, I had lots of free time and then completely lost it once the saw kit arrived. Typically the handle on this style saw is made out of fruitwood or some such dense species. I dont have any of that nonsense lying around, nor do I feel like spending more money. As such, I was left with two options: mahogany or maple. I like maple a lot, you can really almost do anything with it and it isnt too expensive. On the other hand, this saw has a fair amount of brass on it and in my opinion you cant beat brass and mahogany together.

Mahogany it was...


Well, maybe. It aint exactly the toughest wood out there. I used the same template/router bit method that I tried with the ebony tote earlier this week and things were going fine--you can see from the picture that I was about 90% done with the blank--when something caught the bit wrong and the blank just snapped right then and there. Damnit.

I decided to give mahogany one more try, only this time I used the scroll saw for the whole thing--again, just like I ended up doing with the tote. Ive come to the conclusion that the template bit should only be used for simple patterns with lots of straight lines when the wood is close to an inch thick. Thinner stuff is no problem.

Next I drilled the two holes that connect the blade to the handle. I included the drilling sequence in the photo:

1/2" Forstner, 3/16", 1/16", flip, Forstner, 3/16". Very easily done on the drill press.

Next came the part that I was half anticipating, half dreading: setting the blade in the spine. This is the part Ive mentioned previously and included that video of the Gramercy guy beating the blade with a modified cricket bat. I just went straight at it.

Start the blade by hand:

 Then beat it in a little bit at a time:
No sweat.

Then I had to carve out the notch and spline for the now brass-backed saw to sit in the handle. The first step is to mark a nice centerline running around the area Im going to work on. Heres an easy way to establish a quick centerline:
I set my marking gauge reasonably close to what I think looks like the center and then etch a line. Then I flip the piece over and etch another line. In the above picture, these are the two upper outside lines. After I have these two line established, its easy to set the gauge exactly in the middle of the two lines; this would be the centerline. No tedious measuring needed. After this I cut the spline into which the actual blade will fit:

The dozuki was actually perfect for this task because the kerf of the saw is just about equal to the width of the Gramercy blade.

Then I had to remove material so that the brass spine would fit in the handle:
The instructions called for an 11/64" bit for this. Who has one of those lying around? Had to make it work with a 5/32" and a chisel. The blue masking tape on the bit is my depth gauge. That reminds me of a funny video I saw yesterday: